Repara tus cosas Comunidad Tienda

iPad Mini 3 Wi-Fiのロジックボードの交換

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará la guía que incluye este paso.

Volver a la Guía
Inglés
Japonés
Paso 17
iPad Mini 3 Wi-Fi Logic Board Replacement: paso 0, imagen 1 de 2 iPad Mini 3 Wi-Fi Logic Board Replacement: paso 0, imagen 2 de 2

  • Throughout the following procedure, you'll be sliding thin plastic cards between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.

  • Flip the iPad back over and insert a plastic card between the logic board side, speaker end of the battery and the rear case.

  • If you encounter significant resistance, re-heat the iOpener and repeat the previous step to give the adhesive more time to soften.

次の手順では、バッテリーとiPad背面ケースの間に薄いプラスチックカードをスライドさせて、バッテリーを固定している接着剤を分離します。 バッテリーを曲げないように、カードをできるだけ平らに保ってください。バッテリーが損傷し、危険な化学物質が放出される可能性があります。

iPadを裏返し、ロジックボード側、バッテリーのスピーカー側、リアケースの間にプラスチックカードを挿入します。

大きな抵抗を感じる場合は、iOpenerを再度温めて、前の手順を繰り返して接着剤が柔らかくなるまで待ちます。

-[* icon_caution] Throughout the following procedure, you'll be sliding thin plastic cards between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.
+[* icon_caution] Throughout the following procedure, you'll be sliding thin [product|IF145-101|plastic cards] between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.
[* black] Flip the iPad back over and insert a plastic card between the logic board side, speaker end of the battery and the rear case.
[* icon_note] If you encounter significant resistance, re-heat the iOpener and repeat the previous step to give the adhesive more time to soften.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.