Repara tus cosas Comunidad Tienda

Remplacement de la carte mère de l'iPad Mini 3 Wi-Fi

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará la guía que incluye este paso.

Volver a la Guía
Inglés
Francés
Paso 17
iPad Mini 3 Wi-Fi Logic Board Replacement: paso 0, imagen 1 de 2 iPad Mini 3 Wi-Fi Logic Board Replacement: paso 0, imagen 2 de 2

  • Throughout the following procedure, you'll be sliding thin plastic cards between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.

  • Flip the iPad back over and insert a plastic card between the logic board side, speaker end of the battery and the rear case.

  • If you encounter significant resistance, re-heat the iOpener and repeat the previous step to give the adhesive more time to soften.

Tout au long de la procédure suivante, vous allez glisser des fines cartes en plastique entre la batterie et la coque arrière de l'iPad pour décoller l'adhésif. Veillez à garder les cartes aussi plates que possible pour éviter de plier la batterie, ce qui pourrait l'endommager et laisser s'échapper des produits chimiques dangereux.

Retournez l'iPad et insérez une carte en plastique entre la batterie et la coque arrière, du côté de la carte mère et du haut-parleur.

Si vous rencontrez une résistance significative, réchauffez l'iOpener et répétez l'étape précédente pour que l'adhésif ait plus de temps pour ramollir.

-[* icon_caution] Throughout the following procedure, you'll be sliding thin plastic cards between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.
+[* icon_caution] Throughout the following procedure, you'll be sliding thin [product|IF145-101|plastic cards] between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.
[* black] Flip the iPad back over and insert a plastic card between the logic board side, speaker end of the battery and the rear case.
[* icon_note] If you encounter significant resistance, re-heat the iOpener and repeat the previous step to give the adhesive more time to soften.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.