Saltar al contenido principal

DualSense Edge Gehäuserückseite tauschen

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará a todas las 14 guías que incluyen este paso.

Inglés
Alemán

Traduciendo paso 10

Paso 10
DualSense Edge Rear Case Replacement, Replace the slider covers: paso 0, imagen 1 de 3 DualSense Edge Rear Case Replacement, Replace the slider covers: paso 0, imagen 2 de 3 DualSense Edge Rear Case Replacement, Replace the slider covers: paso 0, imagen 3 de 3
Replace the slider covers
  • The rear case holds two small plastic covers for the adaptive trigger assembly adjustment sliders. These may have come off during removal. Place them back in the rear cover now to avoid losing them.

  • Use a pair of tweezers or your fingers to lift the cover from the controller.

  • Slide the flat end of the cover under the plastic tab in the rear case.

  • Make sure it is placed so it can move freely in its groove. The edge with the notch should be towards the middle of the controller.

  • If a cover got bent during the rear case removal or reassembly process, apply a small amount of heat with a hair dryer to restore it to its original shape.

  • During reassembly, you can use a small piece of painter's tape on the outside of the rear case to hold the covers in place.

Die Gehäuserückseite hält zwei kleine Kunststoffabdeckungen für die Einstellschieber der adaptiven Triggereinheit fest. Es kann sein, dass sie beim Ausbau abgefallen sind. Setze sie wieder in die Gehäuserückseite ein, damit sie nicht verloren gehen.

Hebe die Abdeckung mit den Fingern oder einer Pinzette vom Controller ab.

Schiebe das flache Ende der Abdeckung unter die Kunststofflasche in der Gehäuserückseite.

Achte darauf, dass sie sich frei in ihrer Rille bewegen kann. Die Seite mit der Ausbuchtung muss zur Mitte des Controllers hin zeigen.

Wenn eine der Abdeckungen im Laufe der Reparatur verbogen wird, dann erwärme sie ein wenig mit einem Fön, um sie wieder in ihre alte Form zu bringen.

Beim Zusammenbau kannst du die Abdeckungen mit einem kleinen Stück Malerkrepp an der Außenseite des Controllers festkleben.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.