Saltar al contenido principal

Procedimiento de apertura (1.ª y 2.ª generación)

Aviso: Ahora estás editando un requisito previo de la guía que estabas viendo. Cualquier cambio que realices afectará a todas las 8 guías que incluyen este paso.

Inglés
Español
Paso 3
Opening Procedure (1st and 2nd Gen), Anti-Clamp instructions: paso 0, imagen 1 de 3 Opening Procedure (1st and 2nd Gen), Anti-Clamp instructions: paso 0, imagen 2 de 3 Opening Procedure (1st and 2nd Gen), Anti-Clamp instructions: paso 0, imagen 3 de 3
Anti-Clamp instructions
  • The next three steps demonstrate the Anti-Clamp, a tool we designed to make the opening procedure easier. If you aren't using the Anti-Clamp, skip down three steps for an alternate method.

  • For complete instructions on how to use the Anti-Clamp, check out this guide.

  • Pull the blue handle backward to unlock the Anti-Clamp's arms.

  • Place an object under your iPad so it rests level between the suction cups.

  • Position the suction cups near the middle of the right edge—one on the top, and one on the bottom.

  • Hold the bottom of the Anti-Clamp steady and firmly press down on the top cup to apply suction.

  • If you find that the surface of your iPad is too slippery for the Anti-Clamp to hold onto, use tape to create a grippier surface.

Los siguientes tres pasos muestran Anti-Clamp, una herramienta que diseñamos para facilitar el procedimiento de apertura. Si no estás utilizando el Anti-Clamp, omite tres pasos para encontrar un método alternativo.

Para obtener instrucciones completas sobre cómo utilizar el Anti-Clamp, consulta esta guía.

Tira de la manija azul hacia atrás para desbloquear los brazos del Anti-Clamp.

Coloca un objeto debajo de tu iPad de modo que quede nivelado entre las ventosas.

Coloca las ventosas cerca del centro del borde derecho: una en la parte superior y otra en la inferior.

Mantén firme la parte inferior del Anti-Clamp y presiona firmemente hacia abajo la copa superior para aplicar succión.

Si encuentras que la superficie de tu iPad es demasiado resbaladiza para que se sujete el Anti-Clamp, usa cinta adhesiva para crear una superficie con más agarre.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.