Saltar al contenido principal

Procedimiento de apertura (1.ª y 2.ª generación)

Aviso: Ahora estás editando un requisito previo de la guía que estabas viendo. Cualquier cambio que realices afectará a todas las 8 guías que incluyen este paso.

Inglés
Español
Paso 23
Opening Procedure (1st and 2nd Gen), Unscrew the ambient light sensor cable bracket: paso 0, imagen 1 de 2 Opening Procedure (1st and 2nd Gen), Unscrew the ambient light sensor cable bracket: paso 0, imagen 2 de 2
Unscrew the ambient light sensor cable bracket
  • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from.

  • Use a Phillips screwdriver to remove the two screws securing the ambient light sensor cable bracket to the logic board:

  • One 1.3 mm screw

  • One 2.0 mm screw

  • During reassembly, this is a good point to power on your iPad and test all functions before sealing it up. Be sure to power your iPad back down before you continue working.

Durante esta reparación, realiza un seguimiento de cada tornillo y asegúrate de que regrese exactamente al lugar de donde vino.

Utiliza un destornillador Phillips para quitar los dos tornillos que sujetan el soporte del cable del sensor de luz ambiental a la placa lógica:

Un tornillo de 1,3 mm

Un tornillo de 2,0 mm

Durante el reensamblaje, este es un buen punto para encender tu iPad y probar todas las funciones antes de sellarlo. Asegúrate de volver a apagar tu iPad antes de continuar trabajando.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.