Saltar al contenido principal

iPhone SE 2022 배터리 교체

Inglés
Coreano

Información de Guía

= Hecho = Incompleto
    Use this guide shows to remove and replace the battery in the iPhone SE 2022.
    This guide was performed on the ***A2783*** (international) model.
    If your battery is swollen, [[What to do with a swollen battery|take appropriate precautions|new_window=true]].
    ***For your safety, '''discharge your battery below 25%''' before disassembling your device.*** This reduces the risk of fire if the battery is accidentally damaged during the repair.
    ***Note:*** This guide instructs you to fully detach the display assembly; this is intended to prevent accidental damage to the display cables. If you feel comfortable removing the battery without putting undue strain on the display cables, you can skip the steps for detaching the display. Additionally, while it’s possible to remove the adhesive strips securing the battery as soon as you open the phone, this guide recommends first removing the Taptic Engine. Doing so reduces the risk of breaking the lower adhesive strips accidentally, either by snagging them on the Taptic Engine, or by pulling the strips at too sharp of an angle.
    If you do not replace the adhesive seals when reassembling, your device will function normally, but will most likely lose its water protection.
    You’ll need replacement adhesive to reattach components when reassembling the device.

      Pasos de la guía

      Paso 1 — 배터리 신축성 접착제

      iPhone 배터리는 신축성 접착제 네 개로 고정되어 있습니다—상단에 두 개, 하단에 두 개.

      Paso 2 — 배터리 당김 탭 제거하기

      도구로 배터리에 구멍을 내거나 배터리를 구부리지 않도록 주의하세요—구멍이 났거나 구부러진 배터리는 위험한 화학 물질을 유출하거나 화재가 발생할 수 있습니다. 가능하면 손톱이나 뭉툭한 핀셋을 사용하세요. 다른 도구로 접착제를 벗길 수 없는 경우에만 뾰족한 핀셋을 사용하세요.

      Paso 3 — 신축성 접착제 제거하기

      첫 번째 당김-탭을 손가락 또는 뭉툭한 핀셋으로 잡고 배터리에서 멀리, iPhone 하단을 향해 천천히 당기세요.

      Paso 4

      다른 당김-탭 세 개를 손가락 또는 뭉툭한 핀셋으로 잡고 배터리에서 멀리, iPhone 하단을 향해 당기세요.

      Paso 5 — 접착 스트립이 끊어졌다면

      접착 스트립이 끊어지고 배터리가 후면 케이스에 붙어 있으면, 배터리 아랫면에 붙어있는 스트립 근처에 isopropyl alcohol/이소프로필 알코올 (90% 이상)을 몇 방울 떨어 뜨려 제거하세요.

      Paso 6

      고농도 (90% 이상) isopropyl alcohol/이소프로필 알코올이 없다면 iOpener를 준비하여 후면 유리에 최소 3분 동안 적용하여 배터리 아랫면의 신축성 접착제를 부드럽게 하세요.

      Paso 7 — 배터리 분리하기

      배터리를 분리하세요.

      Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.