Saltar al contenido principal

Reemplazo de Switch Romer G del teclado Logitech G PRO

Inglés
Español
Paso 11
Logitech G PRO Keyboard Romer G Switch Replacement: paso 0, imagen 1 de 3 Logitech G PRO Keyboard Romer G Switch Replacement: paso 0, imagen 2 de 3 Logitech G PRO Keyboard Romer G Switch Replacement: paso 0, imagen 3 de 3
  • If you unplugged or turned off your soldering iron, heat it back up to 350 degrees Celsius to solder the replacement Romer G Switch.

  • Take the keyboard and flip it over so you can see the side with all the solder joints.

  • Caution: Remember that soldering irons get to hundreds of degrees and you should be careful to not accidentally touch your skin with it as it can cause moderate to severe burns if left long enough.

  • After locating the new switch on the back of the board, press the soldering iron up against the pin, and push solder into the location of the iron slowly to create your solder joint. Do this for both pins.

Si desconectaste o apagaste tu cautín, caliéntalo de vuelta a 350 grados Celsius para soldar el reemplazo del Switch Romer G.

Toma el teclado y voltéalo para que puedas ver el lado donde están todas las soldaduras.

Precaución: Recuerda que los cautín alcanzan cientos de grados y deberías tener cuidado en no tocarlos con tu piel accidentalmente, ya que podría causar desde un moderado hasta una severo quemada si se deja un largo tiempo.

Después de localizar el nuevo switch en la parte trasera de la tarjeta, presiona el cautín contra el pin, y coloca soldadura en el lugar del cautín para crear la unión. Has esto para ambos pines.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.