Repara tus cosas Comunidad Tienda

バックカバーの取り外し

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará a todas las 14 guías que incluyen este paso.

Volver a la Guía
Inglés
Japonés
Paso anterior

Traduciendo paso 11

Paso 11
Back Cover Removal: paso 0, imagen 1 de 1

  • Remove the back cover.

  • To re-install the back cover:

  • Use tweezers to peel away any remaining adhesive from the phone's chassis. Then clean the adhesion areas with high concentration isopropyl alcohol (at least 90%) and a lint-free cloth to prep the surface for the new adhesive. You don't have to clear out adhesive down to the plastic but larger pieces should be removed.

  • Turn on your phone and test your repair before installing new adhesive and resealing the phone.

  • Carefully apply the new adhesive to the back cover, then line up one edge of the glass against the phone chassis and firmly press the glass into the phone.

バックカバーを取り外します。

バックカバーを取り付けるには：

ピンセットを使用して、携帯電話のシャーシに残っている接着剤をはがします。次に、高濃度イソプロピルアルコール（90％以上）と糸くずの出ない布で接着部分を清掃し、新しい接着剤のために表面を整えます。

携帯電話の電源を入れ、新しい接着剤を取り付け、携帯電話を再封印する前に、修理をテストしてください。

新しい接着剤を裏蓋に慎重に塗布し、ガラスの片方の端を電話の筐体に合わせ、ガラスを電話にしっかりと押し付けます。

または、接着剤を交換せずに裏蓋を再装着することもできます。バックカバーが平らになるのを妨げる可能性のある大きな接着剤の塊はすべて取り除いてください。取り付け後、バックカバーを加熱し、圧力をかけて固定します。防水ではありませんが、通常、接着剤は十分な強度を備えています。

[* black] Remove the back cover.
-[* icon_reminder] To install a back cover:
- [* black] Use tweezers to peel away any remaining adhesive from the phone's chassis. Then clean the adhesion areas with high concentration isopropyl alcohol (at least 90%) and a lint-free cloth to prep the surface for the new adhesive.
+[* icon_reminder] To re-install the back cover:
+ [* black] Use [product|IF145-020|tweezers] to peel away any remaining adhesive from the phone's chassis. Then clean the adhesion areas with high concentration isopropyl alcohol (at least 90%) and a lint-free cloth to prep the surface for the new adhesive. You don't have to clear out adhesive down to the plastic but larger pieces should be removed.
[* black] Turn on your phone and test your repair before installing new adhesive and resealing the phone.
[* black] Carefully apply the new adhesive to the back cover, then line up one edge of the glass against the phone chassis and firmly press the glass into the phone.
- [* icon_note] Alternatively, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it. It won't be waterproof, but the glue is usually more than strong enough to hold.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.