Saltar al contenido principal

Reemplazo del conjunto de LCD de iPad Mini CDMA

Aviso: Ahora estás editando un requisito previo de la guía que estabas viendo. Cualquier cambio que realices afectará a todas las 42 guías que incluyen este paso.

Inglés
Español
Paso 11
iPad Mini CDMA LCD Assembly Replacement: paso 0, imagen 1 de 3 iPad Mini CDMA LCD Assembly Replacement: paso 0, imagen 2 de 3 iPad Mini CDMA LCD Assembly Replacement: paso 0, imagen 3 de 3
  • Starting at the top right of the device, slide the spudger in between the LCD frame and metal backing plate, which will separate the adhesive as you push.

  • The goal is to separate the adhesive, not to pry the LCD up, so keep the pointed tip of the spudger as low as possible to prevent bending the LCD.

  • If inserting the spudger causes the corner of the LCD to bend up, repeat the steps with the guitar pick to further loosen the adhesive.

Empezando en el superior derecho del dispositivo, desliza el spudger entre el marco del LCD y la placa de metal, lo que va a separas el adhesivo conforme empujamos.

La meta es separar el adhesivo, no hacer palanca en el LCD, así que mantén la punta del spudger apuntando hacia abajo lo más que púedas para prevenir doblar el LCD.

Si insertar un spudger causa que la esquina del LCD se doble, repite los pasos con la plumilla para aflojar mas el adhesivo.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.