Saltar al contenido principal

iPhone XS Max バッテリーの交換

Inglés
Japonés
Paso 9
iPhone XS Max Battery Replacement: paso 0, imagen 1 de 3 iPhone XS Max Battery Replacement: paso 0, imagen 2 de 3 iPhone XS Max Battery Replacement: paso 0, imagen 3 de 3
  • Pull and remove the final adhesive strip.

  • The strip may fling the battery when it separates from the iPhone, so hold your hand over the battery to secure it—but don't press down on the battery itself, or the added pressure may cause the adhesive strip to break off underneath the battery.

  • If you removed all four adhesive strips successfully, skip the next step.

  • If the adhesive breaks off underneath the battery and can't be retrieved, apply a few drops of high concentration (over 90%) isopropyl alcohol under the edge of the battery in the area of the broken adhesive strip(s).

  • Wait about one minute for the alcohol solution to weaken the adhesive. Use the flat end of a spudger to gently lift the battery.

  • Don't try to forcefully lever the battery out. If needed, apply a few more drops of alcohol to further weaken the adhesive. Never deform or puncture the battery with your pry tool.

  • Be careful not to damage the ribbon cables or the wireless charging coil directly underneath the battery.

  • For an alternative method to unstick the battery from the case, continue with the next step below.

最後の接着ストリップを引っ張り、取り出します。

iPhoneからストリップが解放された時、バッテリーが飛び出ることがあります。そのため、バッテリーの上に手を添えてくださいーただし、バッテリーを押さえ込まないでください。加えられたプレッシャーによって接着ストリップがバッテリーの下で切断してしまうことがあるためです。

4本の接着ストリップが取り出せたら、次の手順はスキップしてください。

バッテリーの下で接着剤が切断して取り出せない場合は、高濃度(90%以上)のイソプロピルアルコールを数滴、破れた接着剤の部分の電池の縁の下に塗ります。

アルコール溶液が接着剤を弱めるため、約1分待ちます。スパッジャーの平らな方の先を使って、バッテリーをゆっくりと持ち上げます。

バッテリーを力づくで引き抜かないでください。必要に応じてイソプロピルアルコールを数滴注入して、接着剤を弱めます。バッテリーをこじ開けて変形させたり、穴を開けたりしないでください。

バッテリー下に直接搭載されているリボンケーブルやワイヤレス充電コイルを破損しないようにご注意ください。

ケースからバッテリーの接着ストリップを外す他の方法を参照したい方は、次の手順に進んでください。

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.