Saltar al contenido principal

開口方法

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará a todas las 9 guías que incluyen este paso.

Inglés
Japonés
Paso 4
Opening Procedure: paso 0, imagen 1 de 3 Opening Procedure: paso 0, imagen 2 de 3 Opening Procedure: paso 0, imagen 3 de 3
  • Heat an iOpener and thread it through the arms of the Anti-Clamp.

  • You can also use a hair dryer, heat gun, or hot plate—but extreme heat can damage the display and/or internal battery, so proceed with care.

  • Fold the iOpener so it lays on the bottom edge of the iPhone.

  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • Insert an opening pick under the screen and the plastic bezel, not the screen itself.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle a quarter turn.

  • Don't crank more than a quarter turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next three steps.

iOpenerを熱し、リバースクランプのアームに通します。

ヘアードライヤーヒートガン、ホットプレートを使うこともできますが、極端な熱はディスプレイや内蔵バッテリーを損傷させる可能性があるので、注意してください。

iOpenerをiPhoneの下端に重なるように折ります。

1分ほど待つと、粘着剤が剥がれ、隙間ができます。

オープニングピックをスクリーンではなく、スクリーンとプラスチック製ベゼルの下の隙間に差し込みます。スクリーンには差し込まないでください。

クランプで十分な隙間が作れない場合は、さらに接着面に熱を当てて、クランプを1/4程度時計回りに回してください。

一回ごとの作業で1/4以上回さないでください。クランプをまわしたら数秒間待ってください。リバースクランプの効果を待ってから、作業を続けてください。

次の3つの手順をスキップします。

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.