iRobot Roomba 860 Side Brush Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

This guide will provide instructions to replace the side brush that directs debris and contaminants towards the debris extractor to be picked up.

Start by locating the yellow side brush on the underside of the iRobot Roomba 860 near the front of the device.

Using a Philips #2 Point Screwdriver, remove the screw located in the center of the brush.

Pull up on the side brush and it should slide off, free of the motor shaft.
Remove any debris that could be preventing the side brush from spinning and/or replace the side brush.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Miembro Desde 03/02/17

446 Reputación

4 Guías creadas

USFT-CAGLE-S17S13G5

4 Miembros

4 Guías creadas

What to do if the screw head is broken off? Thanks