Saltar al contenido principal

Introducción

Use this guide to remove or replace the two screws securing the iPhone 11 display panel. These are the only screws on the exterior of the iPhone. They use a five-point design that is unique to Apple, requiring a specialty P2 pentalobe driver for removal.

Partes

No se especificaron partes.

  1. Before you begin, discharge your iPhone battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured. Power off your iPhone before beginning disassembly.
    • Before you begin, discharge your iPhone battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.

    • Power off your iPhone before beginning disassembly.

    • Remove the two 6.7 mm-long pentalobe screws at the bottom edge of the iPhone.

    • Opening the iPhone's display will compromise its waterproof seals. Have replacement seals ready before you proceed past this step, or take care to avoid liquid exposure if you reassemble your iPhone without replacing the seals.

Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

Jeff Suovanen

Miembro Desde 06/08/13

377,366 Reputación

260 Guías creadas

Equipo

iFixit Miembro de iFixit

Community

146 Miembros

17,094 Guías creadas

Un Comentario

I was putting in a SIM card on my new iPhone 11 and it bounced and I will not find it. Can you send me one or two and a tool to use bc it is so small?

Dah - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 13

Ultimos 7 días: 124

Ultimos 30 días: 538

Todo El Tiempo: 7,691