Saltar al contenido principal

Introducción

Prereq only for removing the front panel.

Partes

No se especificaron partes.

  1. iPad 2 CDMA LCD Replacement, LCD: paso 1, imagen 1 de 1
    • Remove the four 2.0 mm Phillips #0 screws securing the LCD to the rear case.

  2. iPad 2 CDMA LCD Replacement: paso 2, imagen 1 de 2 iPad 2 CDMA LCD Replacement: paso 2, imagen 2 de 2
    • The front panel ribbon cables are connected beneath the LCD. To access them, you'll need to temporarily flip the LCD over and out of the way.

    • Be very careful when moving the LCD, and do not attempt to remove it from the iPad—its display data cable will remain connected while it is rotated over.

    • Lift the LCD from its long edge closest to the volume buttons and gently flip it out of the rear case—like turning the page in a book.

    • Set the LCD face down on the front panel.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Phillip Takahashi

Miembro Desde 22/08/11

85,007 Reputación

87 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 21

Todo El Tiempo: 583