Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Prereq for removing fan after the hard drive brackets.

Partes

No se especificaron partes.

  1. Use the tip of a spudger to push the fan cable connector out of its socket on the logic board. It is recommended to carefully push on both sides of the connector to walk it out of its socket.
    • Use the tip of a spudger to push the fan cable connector out of its socket on the logic board.

    • It is recommended to carefully push on both sides of the connector to walk it out of its socket.

  2. Remove the following screws securing the fan to the rear enclosure:
    • Remove the following screws securing the fan to the rear enclosure:

    • Two 12.5 mm T10 screws

    • One 9.9 mm T10 screw

  3. Lift and remove the fan from the iMac. Lift and remove the fan from the iMac.
    • Lift and remove the fan from the iMac.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 29