Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará a todas las 2 guías que incluyen este paso.
Traduciendo paso 1
Paso 1
-
Using a screwdriver with a J000 Phillips bit, remove the fourteen 3.175 mm screws.
-
Using a plastic opening tool, pry part of the panel up starting from the sides of the battery slot.
-
Use plastic tweezers to release the rest of the panel from plastic bits holding it in place and pry the panel up around the sides surrounding the fingerprint sensor and camera lens; set the back panel off to the side.
Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.