Cambios al paso #5
Editado por Emmett Normand —
Edicion aprobada por Emmett Normand
- Antes
- Después
- Sin cambios
Líneas de Paso
| [* red] Remove this Phillips head screw | |
| [* green] Disconnect the DC connector it can be identified as having only 2 wires | |
| [* orange] Disconnect the power button it is a temporary switch and can be identified as having 4 wires | |
| - | [* blue] Disconnect the Hall effect sensor it can be identified by having 6 wires. A hall effect sensor is used to tell the board where the motor is in its rotation. |
| - | [* icon_note] You will most likely need to remove silicone and hot glue to remove the connectors |
| + | [* blue] Disconnect the Hall effect sensor it can be identified by having 6 wires. |
| + | [* icon_note] A hall effect sensor is used to tell the board where the motor is in its rotation. |
| + | [* icon_caution] You will most likely need to remove silicone and hot glue to remove the connectors |