|
Introduction |
1* Take the battarybattery out.
| | 2*Unscrew the whole back. |
3*You will sesee a connector down at the charger port take them off and you can blow some air to take the dirt off.
| | 4* Take some paper and fold it 4 to 6 times(small one) | | | 5* After folding it make sure it is the size of the connector that is next to the Camera. | | | 6*Place the folden paper on top of the connector. | | | 7*Slowly get back all the plastic covers. | | | 8*Screw in all the screws. |
9*Place the battarybattery, SD Card and the Sim back
| | 10*Power on the Phone. | | | | 99.9% It will work. | | UPDATE:
If you want to take it a step further ,
| | get some thermal paste |
and remove the whole circuit board and butput some on the spot (as shown onin the picture) do NOT put too much a dot will be enough...
after that, you can go ahead anand place the circuit board back in place, then place the paper on the connector(follow the steps 6-10) | | | *Even thermal pad might do the job. | | | Thanks, |
I hope this will fix the problem ! |
|