Introducción

This guide is an internal prereq.

  1. Use the flat end of a spudger to release the clips securing the RF module shield along the top and the left edge of the RF module. It may be easier to use your fingernail to release the clips from the RF module. Remove the RF module shield from the console.
    • Use the flat end of a spudger to release the clips securing the RF module shield along the top and the left edge of the RF module.

    • It may be easier to use your fingernail to release the clips from the RF module.

    • Remove the RF module shield from the console.

  2. Remove three 5.6 mm T8 Torx screws securing the RF module to the metal chassis.
    • Remove three 5.6 mm T8 Torx screws securing the RF module to the metal chassis.

    for whatever reason the T8 screws holding the RF receiver on my unit were torqued on pretty hard. almost impossible to get off. IS taking the RF off really necessary?

    matt337 - Contestar

  3. ¡Envío gratuito para todos los pedidos de más de USD100 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda
  4. Grasp the RF module and lift it straight up to disconnect it from its socket on the motherboard. Remove the RF module from the console.
    • Grasp the RF module and lift it straight up to disconnect it from its socket on the motherboard.

    • Remove the RF module from the console.

  5. Remove the following screws securing the motherboard to the metal casing:
    • Remove the following screws securing the motherboard to the metal casing:

    • Nine gold 11 mm T10 Torx screws.

    • Eight black 5.6 mm T8 Torx screws.

    • If you are reassembling your Xbox 360 after installing the Red Ring of Death Fix Kit, the eight T8 Torx screws circled in orange are not reused.

    kinda hard for a KID to do this huh also I am a 9 year old you get it

    Andy Ewing - Contestar

    The T8’s were T9’s on mine. This guide could be wrong, or my toolkit was mislabeled. If you can’t get the T8’s out, try a T9 before stripping the screws!

    Braden Estenson - Contestar

  6. Turn the Xbox over, being careful not to let the motherboard fall out of the chassis. Lift the motherboard assembly from its front edge.
    • Turn the Xbox over, being careful not to let the motherboard fall out of the chassis.

    • Lift the motherboard assembly from its front edge.

    • Be careful not to damage the sockets as you rotate the motherboard away from the metal casing.

    • Remove the motherboard assembly from the metal casing.

    Kisses daddy..,.

    rhonda zarro - Contestar

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 979