Repara tus cosas Comunidad Tienda

Unbranded UB-15MS10 Speaker Replacement

Guía Archivada
Esta guía se mantiene únicamente para fines históricos. Utiliza la última versión de la guía para llevar a cabo tu reparación.

Introducción

This guide walks you through how to replace a broken speaker on your UnBranded Tablet.

Qué necesitas

  1. Unbranded UB-15MS10 Speaker Replacement, Back Panel: paso 1, imagen 1 de 1

    • Remove the cover over the Micro SD outlet by using a plastic opening tool to pry open and push out the cover panel.

    Traducir

  2. Unbranded UB-15MS10 Speaker Replacement: paso 2, imagen 1 de 1

    • Remove the two 4-mm #0 screws from the inside of the Micro SD compartment.

    Traducir

  3. Unbranded UB-15MS10 Speaker Replacement: paso 3, imagen 1 de 2 Unbranded UB-15MS10 Speaker Replacement: paso 3, imagen 2 de 2

    • Insert blue guitar picks in the crease between the top and bottom panels starting on the same end as the Micro SD slot.

    • Inserting the picks directly under the Micro SD compartment was the easiest place to get started. It still requires some force.

    Traducir

  5. Unbranded UB-15MS10 Speaker Replacement: paso 4, imagen 1 de 1

    • Insert the black spudger between the guitar picks in order to pry open gaps between the blue guitar picks.

    • As the gaps open, slide the guitar picks along the sides to separate the panels.

    Traducir

  6. Unbranded UB-15MS10 Speaker Replacement: paso 5, imagen 1 de 1

    • Pry all four sides apart using the blue guitar picks and the black spudger until they can easily be pried apart by hand.

    Traducir

  7. Unbranded UB-15MS10 Speaker Replacement, Speaker: paso 6, imagen 1 de 1

    • Remove the yellow tape from the speaker.

    Traducir

  8. Unbranded UB-15MS10 Speaker Replacement: paso 7, imagen 1 de 1

    • Remove the two 4-mm #0 screws holding the speaker in place.

    • The copper-colored plastic piece covering the speaker does not need to be removed from the device, move it to the side to reach the screws.

    Traducir

  9. Unbranded UB-15MS10 Speaker Replacement: paso 8, imagen 1 de 1

    • Remove the silver tape covering the speaker's black and red wires.

    Traducir

  10. Unbranded UB-15MS10 Speaker Replacement: paso 9, imagen 1 de 1

    • Reflow the solder of the black and red wires from the circuit board by using the soldering iron.

    • For more information about using a soldering iron click here.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 7 otros colaboradores

Jordan Turk

Miembro Desde 09/21/15

331 Reputación

2 Guías creadas

Insignias: 10

+ 7 más insignias

Equipo

IUPUI, Team 2-1, Baechle Fall 2015 Miembro de IUPUI, Team 2-1, Baechle Fall 2015

IUPUI-BAECHLE-F15S2G1

3 Miembros

3 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 5

Ultimos 30 días: 5

Todo El Tiempo: 725