Introducción

This manual will show you how to correctly remove wheels, change bearings, and install new wheels onto your skateboard.

You may reuse old bearings, or purchase new ones.

With a 13mm wrench, remove the axle nut located in the center of the wheel.
  • With a 13mm wrench, remove the axle nut located in the center of the wheel.

  • Set the axle nut aside, and remove the wheel.

I am having stick like nut

Srijan Suryansh - Contestar

Position the wheel at the end of the axle.
  • Position the wheel at the end of the axle.

  • To remove the bearings, gently pry the wheel at a downward angle.

  • Perform this prying process on both sides of the wheel.

  • A bearing spacer should fall out once the bearings are removed.

Agregar Comentario

  • Position the new wheel on a flat surface.

  • Press the bearing into the hole of the new wheel.

  • Press firmly until the bearing snaps into place. The bearing's outside edges should be flush with the inside bottom edge of the wheel.

Agregar Comentario

  • Flip the wheel over.

  • Insert the bearing spacer into the back the wheel.

Agregar Comentario

  • Repeat the method from Step 3 to insert a bearing into the backside of the wheel.

  • With the bearings in place, the wheel can be placed on the axle.

Agregar Comentario

  • Slide one washer onto the axle.

Agregar Comentario

  • Slide the wheel onto the axle.

  • The axle should go through both bearings and the bearing spacer.

Agregar Comentario

  • Slide the second washer onto the axle on the outside of the wheel.

Agregar Comentario

  • Tighten the axle nut firmly.

  • Do not over tighten. The wheel should spin freely.

  • Repeat steps 1-9 for the remaining wheels.

Agregar Comentario

Conclusión

Once your wheels are installed, you can ride your skateboard. If you feel your wheels hitting the bottom of your deck when you are turning, you may want to refer to the Wheel Bite Prevention guide.

5 personas más completaron esta guía.

Jared Stine

Miembro Desde 05/10/12

639 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 6-32, Regan Fall 2012 Miembro de Cal Poly, Team 6-32, Regan Fall 2012

CPSU-REGAN-F12S6G32

5 Miembros

5 Guías creadas

Very helpful - just got a skateboard for my son and used this guide to adjust two wheels.

emvxl - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 25

Últimos 7 Días: 226

Últimos 30 Días: 1,240

Todo El Tiempo: 36,518