Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
Resumen del Video
-
Este paso está sin traducir. Ayuda a traducirlo
-
Push the lift away button and pull the handle up to separate the body from the wand section.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Push lift away button on the wand then lift up on the top section to separate.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lay the head nozzle piece upside down.
-
Rotate the three gray taps to the unlock position.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With your fingers, pry and pull the brush cage open.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 13 screws (circled in yellow) using a phillips screwdriver.
-
Remove the one screw (circled in red) that has a Torx head (might be Phillips head on some models).
-
Remove the horizontal screw (circled in orange) that attaches the gray side panel (necessary to remove the white cap on the roller brush in step 8)
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift up the top cover now that all of the screws have been removed.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Detach the headlight’s red and black wires from plastic clip as shown.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Follow the headlight’s red and black wires to the circuit board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unclip the 2-pin electrical connector by pressing the tab then lift up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully lift the headlights and its wires from the vacuum assembly.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.
3 comentarios
Shark sent a brand new replacement nozzle to me (covered in their 5yr warranty) but head lights STILL DO NOT WORK - which makes me wonder where else the issue could be because the above “fix” would not have fixed my vacuum head lights.
These steps are great, but how do you ACTUALLY replace the led light strip itself? Do u need a special strip? Just any led strip? U left a few more steps out. Is like to replace mine instead of buying a whole new vacuum head.
Protip: Print out a copy of the first photo for step 6 as large as will fit on the page. Tape it to a piece of foam board and poke the screws into it as you remove them. This makes it easy to remember which screw came from where.