Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the back panel by inserting your fingers into the indentations next to the tabs. Press the tabs inward towards each other while pulling the back panel toward you.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the T10 Torx Security Bit Screwdriver, unscrew the screws on the upper left and right corners of the inner panel to remove the inner back panel.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Press down on the two plastic hinges to remove the upper portion of printer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grasp the plastic plug on the end of the speaker wire, then gently pull the plug away from the printer until the wire is removed.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Rotate the printer so the paper tray is facing towards you.
-
Gently lift the scanner tray up and away from the printer.
-
Press the gray plastic tabs inward to release the tabs from the printer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Returning to the back of the printer, remove the scanner from the back hinges.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently grasp and unplug the two white ribbon cables from the printer body.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unplug the white plastic multi-wire connector (with orange, black, red, and brown wires) from it's port.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Detach the scanner tray from the printer by lifting the scanner tray off the printer body.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Detach the white ribbon wire from the scanner head by pulling gently at the connection.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the gray drive belt from the black tab to disconnect the drive belt from the scanner head.
-
Remove the scanner head from the scanner by gently rotating and then lifting.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Place the new scanner head in the scanner tray by fastening the drive belt into the black tab.
-
Once the drive belt is secured, rotate the scanner head back into position.
-
Re-attach the white ribbon wire to the connection from Step 10.
-
Cancelar: No complete esta guía.
3 personas más completaron esta guía.
2 comentarios
Ok, but where do I purchase a new scanner head???
the step between 9 and 10 doesn't seem to make sense. it never established that the scanner head is broken...I couldn't identify where step 10 scanner head came up ...no where did it show the scanner between step 1 and step 9...Please offer an explanation...
by step 9 the scanner package had already removed...i m afraid I wont here from ifixit because the printer is about 20 years old.