Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using your thumb, press down and slide the back cover away from the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the battery from the phone by using your plastic opening tool to find a gap at any edge of the battery and lifting the battery up.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips #00 screwdriver, remove the six 4mm screws holding the back case together.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a plastic opening tool to pry the case off. To do this, find a gap on any side of the phone, top preferably, and slip the tip of the tool in the gap.
-
Now use moderate strength and slowly maneuver the tool around the outside until the case becomes loose.
-
Using your fingers, take the case off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The antenna is located on the bottom of the phone. It is the small rectangular shaped object sticking out on one of the ends.
-
Use a plastic opening tool to prop the antenna out. To do so, slip the tip of the tool on one of the edges of the antenna. Use moderate pressure to pry the antenna out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a plastic opening tool, disconnect the connector leading from the antenna to the phone.
-
Equipo
Cal Poly, Team 3-12, Regan Fall 2011 Miembro de Cal Poly, Team 3-12, Regan Fall 2011
CPSU-REGAN-F11S3G12
4 Miembros
14 Guías creadas
