Saltar al contenido principal

Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.

Qué necesitas

  1. Este paso está sin traducir. Ayuda a traducirlo

    : paso 1, imagen 1 de 3 : paso 1, imagen 2 de 3 : paso 1, imagen 3 de 3
    • This is the back of the device and where you will begin to take it apart

    • It is neccesary to remove this piece first before removing the bigger back piece.

    • Use the plastic opening tools to pry along the indicated box.

    • Lift up the silver piece to reveal the rest of the back cover.

  2. Este paso está sin traducir. Ayuda a traducirlo

    : paso 2, imagen 1 de 3 : paso 2, imagen 2 de 3 : paso 2, imagen 3 de 3
    • Unscrew the three 5 mm screws indicated by the red circles with the Philips #00 screwdriver.

    • Using the plastic opening tools pry along the bottom of the device, moving to the sides of the cover to the top.

    • Remove the back cover.

    • At this point use anti-static gloves or do NOT take it apart on carpet.

  3. Este paso está sin traducir. Ayuda a traducirlo

    : paso 3, imagen 1 de 3 : paso 3, imagen 2 de 3 : paso 3, imagen 3 de 3
    • Carefully remove all of the ribbons that connect over the battery.

  4. Este paso está sin traducir. Ayuda a traducirlo

    : paso 4, imagen 1 de 3 : paso 4, imagen 2 de 3 : paso 4, imagen 3 de 3
    • Remove all of the 3 mm screws indicated by a red circle with the #00 Philips Screwdriver.

    • Disconnect the battery connector from the motherboard.

    • Now you may remove the battery. The replacement battery should be 3.7 Volts and 25.9 kWh.

Linea de Meta

49 personas más completaron esta guía.

Tyler Salomone

Miembro Desde 09/22/14

1,020 Reputación

3 Guías creadas

Equipo

USF Tampa, Team 3-7, Brown Fall 2014 Miembro de USF Tampa, Team 3-7, Brown Fall 2014

USFT-BROWN-F14S3G7

3 Miembros

9 Guías creadas

13 comentarios

In Step 3, mention that you need to lift up on the black locks to take out the ribbons.

John Peterson - Contestar

Actually, on my device one lock was colored faun (beige). Lift them seen from the edge of the Note, not on the cable side.

dada64 -

Also, mention that you can disconnect the battery from the device by gently pulling out the battery and gently lifting up the wires.

John Peterson - Contestar

This is not a plug to be pulled in the direction of the cables but vertically off the board. Putting it back in you simply plug the contacts down first, then the cable side of the plug.

dada64 -

When replacing the back cover, hook the bottom edge into the frame along the edge before trying to snap the rest in place along the sides.

charliesmallman55 - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 7

Ultimos 7 días: 22

Ultimos 30 días: 102

Todo El Tiempo: 88,479