Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
-
Ubique la lengüeta de liberación de la batería en la parte inferior del G4.
-
Deslice la lengüeta de liberación de la batería hacia la izquierda y levante la batería de la computadora.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the seven T8 Torx screws from the lower case.
-
Using your thumbs, slide the lower case toward the front of the computer.
-
The lower case may stick in the front on a tab just above the center of the optical drive. Be careful as you work the case off, or you may break the thin strip of plastic just above the drive.
-
Lift the lower case off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Firmly grasp the plastic tab attached to the Airport card and pull up and to the left.
-
Disconnect the antenna cable from the left side of the Airport card.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the hard drive ribbon from the logic board using a spudger or the tip of your finger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To free the hard drive, remove the two T8 Torx screws from the right wall of the battery housing.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the hard drive by lifting the left edge up and out of the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect and remove the indicated orange ribbon cable.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the pink and white inverter cable from the inverter board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two silver T8 Torx screws from the black plastic bar.
-
Lift the black plastic bar out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the two orange connectors from the logic board, removing tape as necessary.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the drive up on the right side so that you can access and disconnect the modem cable and inverter cable.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the drive by lifting the right edge up and out of the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two T6 Torx screws from the modem.
-
Lift the modem off the optical drive, carefully guiding the orange ribbon cable through the space in the drive mount.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.