Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a coin or a spudger to turn the battery locking screw 90 degrees clockwise.
-
Lift the battery out of the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four Phillips screws from the memory door.
-
Slide the memory door away from the memory compartment.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the following 8 screws:
-
Two 3 mm Phillips in the battery compartment, on either side of the battery contacts.
-
Two 12 mm Phillips on either side of the memory compartment.
-
Four 16 mm Phillips along the hinge.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Rotate the computer 90 degrees clockwise, so that the power receptacle faces you.
-
Remove the three 3 mm Phillips screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the computer 90 degrees clockwise so that the hinge faces you.
-
Remove the bottom 5 mm Phillips screw on either side of the hinge (two total).
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Rotate the computer 90 degrees clockwise, so that the ports face you.
-
Remove the three 3 mm Phillips screws.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the computer over and open the display.
-
Remove the two 1.5 mm hex screws in either corner, next to the display (a T6 Torx driver will work, but repeated use will strip the screws).
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grasp the back corners of the upper case and pull up. Do not pull the upper case off yet; you still need to disconnect the keyboard and trackpad cable.
-
Lift the back of the case up and work your fingers along the sides, freeing the case as you go. Once you have freed the sides, you may need to rock the case up and down to free the front of the upper case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Rotate the upper case up and toward the screen, so that the upper case rests against it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the orange tape securing the trackpad ribbon to the logic board.
-
Disconnect the trackpad ribbon from the logic board.
-
Remove the upper case from the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three long silver Phillips screws from the retaining bracket on the left side of the optical drive.
-
Remove the retaining bracket.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the large orange hard drive cable from the logic board, removing tape as necessary.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the hard drive up from the right side and remove it from the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two silver Phillips screws from the modem board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the large orange ribbon cable from the top of the modem.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the modem up and disconnect the remaining cable, at which point the modem will be free.
-