PowerA Spectra Contoller Bumper Replacement

Introducción

This guide informs you on the proper way to remove the bumper buttons on the PowerA Spectra Controller.

The bumper buttons are two identical buttons located on top of the controller directly across from each other. These buttons may have to be replaced due to worn out springs or joints.

Make sure to disconnect any electrical connections before maintenance.

Qué necesitas

Paso 1 Rear Case

PowerA Spectra Contoller Bumper Replacement, Rear Case: paso 1, imagen 1 de 1

Flip the controller over so the backplate is facing up.

Traducir

Paso 2

Use a Phillips #2 screwdriver to remove the eight 7.8 mm screws that secure the rear case.

Traducir

Paso 3

Hold the front case in one hand and pull the rear case off.

Traducir

Paso 4 Bumper

PowerA Spectra Contoller Bumper Replacement, Bumper: paso 4, imagen 1 de 1

Remove the two 7.8 mm screws from the motherboard with a Phillips screwdriver.

Traducir

Paso 5

Grasp the front plate and motherboard and slowly pull apart to access the bumpers.

Traducir

Paso 6

Use angled tweezers to unclip the bumper spring from the front plate.

Traducir

Paso 7

Lift up the bumper and slide off the bumper axis to remove.

Traducir

Conclusión

To reassemble your device, follow the above steps in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.