Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips #0 screwdriver, remove the four 10mm screws located on the back of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert the plastic opening tool at the indent.
-
Gently use a forward and backward motion to safely pop open the cover.
-
Using your hands to further pull it apart.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once the device is opened, lift the battery out of the black plastic holder.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips head screwdriver, remove the 9mm screw located to the right of the battery, which is connected to the inner plastic frame.
-
Using the plastic opening tool carefully take out the grey cylindrical piece (vibrator) that is also attached to a wire.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently pull out the small grey cylindrical piece (vibrator).
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using tweezers, remove the small piece with a cylindrical top that is located to the left of the inner plastic frame.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using one hand to hold the device, and the other hand to squeeze the inner plastic frame.
-
Remove by squeezing the inner plastic frame, lift and pull it towards you.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently pull on the white piece connecting the battery and the connector.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the five 1.2 mm screws from upper portion of the controller.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Cautiously remove the circular white piece at the top without removing the LED inside.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the blue strip that is connected to the trigger button from the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert tweezers between the LED case and the LED clear plastic cover.
-
Lift the edge of the LED clear cover clip to be able to remove the cover.
-
Repeat the previous step to the other side.
-
Remove the LED cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the LED board using a blue opening tool to lift the board.
-
After the board is loose, remove the LED board.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.
3 comentarios
Okay, going to try this. Do I have to solder the white strip back onto the board?
did you ever get this done? need to know the same.