Saltar al contenido principal

Philips HD9252 Transformer Replacement

Qué necesitas

  1. Philips HD9252 Transformer Replacement, Top: paso 1, imagen 1 de 1
    • Insert a nylon spudger underneath the top of the device.

    • Leverage the tool and pop off each of the eight tabs holding the plastic cover in place.

  2. Philips HD9252 Transformer Replacement: paso 2, imagen 1 de 1
    • Remove the four 12.4 mm screws in each of the corners using a JIS #1 screwdriver.

  3. Philips HD9252 Transformer Replacement: paso 3, imagen 1 de 1
    • Remove the top by lifting it upwards and setting it down.

    Hi, I cannot lift the top half because it's blocked by the exhaust vent. Any step that I am missing?

    Lorenzo Giraudi - Contestar

  4. Philips HD9252 Transformer Replacement, Transformer: paso 4, imagen 1 de 1
    • Remove the two 39.5 mm screws attached to the black piece of the transformer using a JIS #1 screwdriver.

  5. Philips HD9252 Transformer Replacement: paso 5, imagen 1 de 1
    • Remove the top piece, using a Phillips #2 screwdriver, to get the whole transformer.

  6. Philips HD9252 Transformer Replacement: paso 6, imagen 1 de 2 Philips HD9252 Transformer Replacement: paso 6, imagen 2 de 2
    • Remove the brown and white wire attached to the transformer using a spudger.

    • Disconnect both the brown and white cables.

  7. Philips HD9252 Transformer Replacement: paso 7, imagen 1 de 1
    • Replace the transformer.

Conclusión

To reassemble your device, follow these instructions in reverse order.

1Guía Comentario

This is not the transformer, it is the coil of the shaded-pole motor.

Werner Hinzmann - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 5

Ultimos 7 días: 21

Ultimos 30 días: 67

Todo El Tiempo: 462