Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Make sure the power is off by making sure the switch is to the right. The power switch can be found on the top side of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the Philips #00 Screwdriver on the screw on the left side of the camera.
-
There is another screw on the underside of the camera that is part of the left cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the Philips #00 Screwdriver to remove the two screws on the right cover of the camera.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the Philips #00 Screwdriver to remove the screws on the bottom side of the camera.
-
Make sure to grasp the camera because these are the last two screws that hold the camera in place.
-
Carefully place the opening tool between the two covers and gently apply force upward to separate the covers.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
There are two digitizer cables that connect the LCD Screen to the camera motherboard.
-
The digitizer cables are held down by retaining flats.
-
Carefully use the opening tool to push the retaining flats upward to allow the digitizer cables to disconnect.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully use the opening tool to remove the LCD Screen from the glass frame.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully use the opening tool to seperate the screen from the frame.
-
Equipo
University of North Texas, Team S6-G1, Thomas Spring 2018 Miembro de University of North Texas, Team S6-G1, Thomas Spring 2018
UNT-THOMAS-S18S6G1
4 Miembros
9 Guías creadas
