Introducción

This guide shows you how to take off the back panel to the Palm Treo 680 in order to reach the other components within side the phone.

Remove the battery cover by pressing on the small rectangular button location the back of the phone. Remove the battery cover by pressing on the small rectangular button location the back of the phone.
  • Remove the battery cover by pressing on the small rectangular button location the back of the phone.

Agregar Comentario

Remove the battery by pulling it out toward you.
  • Remove the battery by pulling it out toward you.

Agregar Comentario

Unscrew the 0.266 inch top-left screw with a T6 Torx Screwdriver. Be sure to remove the stylus in order to access the screw.
  • Unscrew the 0.266 inch top-left screw with a T6 Torx Screwdriver.

  • Be sure to remove the stylus in order to access the screw.

Use a T5 Torx screwdriver instead of a T6. T6 is too big.

Rhebakah Thomas - Contestar

I found T5 too large as well. T4 seeems to work

Absent Minded Professor - Contestar

Using the spudger, remove the rubber rectangular cover located in the upper right hand side of the device. Unscrew the 0.266 inch screw with the T6 Torx Screwdriver.
  • Using the spudger, remove the rubber rectangular cover located in the upper right hand side of the device.

  • Unscrew the 0.266 inch screw with the T6 Torx Screwdriver.

    • If there is a red Palm sticker covering the screw, just puncture it to access the screw.

Agregar Comentario

Remove the remaining two 0.266 inch screws at the bottom of the device.
  • Remove the remaining two 0.266 inch screws at the bottom of the device.

Agregar Comentario

Turn the phone 90 degrees to the right, so the screen is facing the right side. Use a spudger to carefully separate the back panel from the front panel to access all the various components inside the phone. Separate the covers from the left side of the device as indicated in the picture. The right side contains orange ribbons that are easily damaged.
  • Turn the phone 90 degrees to the right, so the screen is facing the right side.

  • Use a spudger to carefully separate the back panel from the front panel to access all the various components inside the phone.

  • Separate the covers from the left side of the device as indicated in the picture. The right side contains orange ribbons that are easily damaged.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Maiya123

Miembro Desde 22/10/09

36 Reputación

12 Guías creadas

Equipo

Cal Poly, Team 6-4, Maness Fall 2009 Miembro de Cal Poly, Team 6-4, Maness Fall 2009

CPSU-MANESS-F09S6G4

4 Miembros

12 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 2,674