Cancelar

PSP Go Top Cover Replacement

Escrito Por: Walter Galan (y 2 de otros participantes)

Comentarios: 0
Favoritos: 6
Terminaciones: 1

PSP Go Top Cover Replacement

Dificultad

Fácil

Pasos

3

Tiempo Requerido

Sugerir un tiempo??

Introducción

Use this guide to replace your PSP Go's top cover.

Herramientas

Comprar estas herramientas

Phillips #00 Screwdriver

USD6.99

Comprar
iFixit Opening Tools

USD1.99

Comprar

Partes

Comprar estas partes

Sony PSP Go Top Cover

USD7.99

Comprar

Paso 1 Back Cover

Unscrew the four Phillips screws on the back of the PSP Go.

Rotate the PSP so you can see the top of the device.

Unscrew the four Phillips screws on the back of the PSP Go.
Rotate the PSP so you can see the top of the device.
Unscrew the two Phillips screws next to the volume buttons.

Paso 2

Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.

Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).

Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.
Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).
Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

Paso 3 Top Cover

Pull the top cover upwards gently from its housing.

Pull the top cover upwards gently from its housing.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 2 otros colaboradores

Walter Galan

598,139 Reputación

1,203 Guías creadas

+ 50 más insignias

0 Comentarios

Agregar un comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 6

Todo El Tiempo: 5,222