Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
-
Desatornilla los cuatro tornillos Phillips en la parte posterior de la PSP Go.
-
Gira la PSP para que puedas ver la parte superior del dispositivo.
-
Desatornilla los dos tornillos Phillips al lado de los botones de volumen.
-
-
-
Tira de la cubierta superior hacia arriba suavemente desde su alojamiento.
-
-
-
Usa una herramienta de apertura de plástico para levantar suavemente el conector del gatillo izquierdo.
-
-
-
Usa la herramienta de apertura de plástico para despegar suavemente la etiqueta adhesiva "Warranty Void". Comienza en un borde, como se muestra, y desliza la herramienta de lado a lado hasta que la etiqueta se elimine solo de la batería.
-
-
-
-
Retira el único tornillo Phillips que sujeta la placa lógica a la carcasa interior.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a #00 Phillips screwdriver to remove the four display screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Wedge a plastic opening tool in the location shown in the first picture, and slightly separate the metal frame from the plastic front panel.
-
Slide the plastic opening tool around the perimeter of the display, increasing the gap between the metal frame and the front panel.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a plastic opening tool to disconnect the display cable from the rest of the device.
-
The PSP Go should now look similar to the second picture.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Wedge a plastic opening tool between the plastic front panel and display. Be very careful that you wedge it in the same location shown in the first picture.
-
Slide the plastic opening tool across the length of the display. This should loosen the glue binding the display to the plastic front panel.
-
Rotate the display 180 degrees and free the bottom side of the display in the same manner.
-
Cancelar: No complete esta guía.
3 personas más completaron esta guía.
Un comentario
I don’t have this device, but I’m curious if the front panel is just an border or if it is a sheet, because the later would mean you don’t have to replace the screen to get rid of scratches. I assume this is the case, but just wanted to be sure.