Esta traducción podría no reflejar los cambios más recientes añadidos a la guía de referencia. Ayúdanos a actualizar la traducción o revisa la guía original.
Qué necesitas
-
-
Pon el PSP con la pantalla hacia abajo, que la parte del UMD se encuentre apuntando hacia arriba,
-
Localiza la puerta de la bateria y abrela.
-
Remueve la bateria desde adentro hacia afuera.
-
-
-
Localiza el sticker debajo donde deberia ir la bateria que dice: "En: Warranty Void if Seal Damaged."
-
Remueve el sticker usando herramientas para abrir dispositivos.
-
-
-
-
Remueve la barra de inicio haciendo palanca gentilmente en los lados izquierdo y derecho de está con herramientas de apertura. Levanta la barra fuera del dispositivo.
-
-
-
Con la barra de inicio fuera de lugar, gentilmente haz palanca en el display usando herramientas de apertura.
-
Levanta las pestañas negras del conector del cable plano usando herramientas de apertura. Jala las cintas hacia abajo del PSP para desconectarlas.
-
Gentilmente levanta el display.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully disconnect the UMD drive ribbon cable from the logic board. Use the PSP opening tools to push the black tabs on the connector horizantally to free the cable.
-
At this point it is useful to tape the loose metal parts with some masking tape so they don't fall out whilst you have the PSP the other way up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With the front side of the PSP facing you, locate small white plastic box with metal spring attached.
-
Remove the white plastic box and spring from the PSP.
-
-
-
Coloque la PSP de modo que el dispositivo UMD mire hacia arriba.
-
Con la unidad UMD abierta, ubique el soporte de expulsión de UMD de aluminio. Pellizca la parte superior de los brazos hacia adentro para separarlos de la puerta del UMD.
-
El soporte de expulsión del UMD ahora se puede extraer fácilmente.
-
Haga palanca suavemente en el lado izquierdo de la puerta del UMD para retirarla.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With the UMD door off, locate and remove the four 4mm Phillips screws that hold in the UMD Drive in place.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With the four screws unscrewed, the UMD Drive can be removed. Gently lift the drive from its housing.
-
Cancelar: No complete esta guía.
34 personas más completaron esta guía.
Un agradecimiento especial a estos traductores:
11%
¡ Carlos Jimenez Flete nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›
3 comentarios
I've used this guide multiple times and it is simply the best out there. You should simply title it "PSP disassembly" as I have used it just to take the 2000 apart and not just replace the UMD drive.
This guide was very helpful in replacing the UND drive in my 2000. Unfortunately, it turns out that the UMD drive was not causing the issue it is having.
Lots of guessing in this guide, better not use it and look up a YT video.