Repara tus cosas Comunidad Tienda

Otium Bluetooth Headphones Battery Replacement

Introducción

The Otium Bluetooth Headphones are rated for 500 charge cycles. If your headphones will not hold charge, or charge at all, you may need to replace the battery.

Qué necesitas

    • Power off your earbuds first.

    • Use a pry tool to unclip the cover of the left earbud.

    Editar

  2. Otium Bluetooth Headphones Battery Replacement: paso 2, imagen 1 de 2 Otium Bluetooth Headphones Battery Replacement: paso 2, imagen 2 de 2

    • Carefully remove the battery from the housing.

    • The battery is connected by two fragile wires.

    • Shown is a 3.7v 100mAh Lithium Polymer (LiPo) battery.

    Editar

  4. Otium Bluetooth Headphones Battery Replacement: paso 3, imagen 1 de 2 Otium Bluetooth Headphones Battery Replacement: paso 3, imagen 2 de 2

    • Carefully peel back the rubber cover from the protection circuit module (PCM).

    • Remove the cover and save to re-use.

    • The rubber is attached using Kapton tape and hot glue.

    Editar

  5. Otium Bluetooth Headphones Battery Replacement: paso 4, imagen 1 de 2 Otium Bluetooth Headphones Battery Replacement: paso 4, imagen 2 de 2

    • Carefully bend the PCM away from the battery to make desoldering the two wires easier.

    Editar

    • Use a soldering iron to desolder the two wires from the PCM.

    • Adding a JST connector would make future repairs much easier!

    • Recycle your old battery!

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 1 otro colaborador

Geralt

Miembro Desde 11/28/14

1,894 Reputación

2 Guías creadas

Insignias: 16

+ 13 más insignias

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 8

Ultimos 30 días: 45

Todo El Tiempo: 787