Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the thumbtab molded on the bottom of the phone, pry the back cover off using either a fingernail or a plastic opening tool.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
There is a molded notch in the white frame of the phone near the top right of the battery. Using either a finger or a plastic opening tool, utilize the notch to lift up on the battery, and remove it from the device.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a T5 screwdriver bit, remove the (6) 5.0 mm screws along the outside edge of the frame.
-
Using a metal spudger, wedge the 6 plastic tabs molded into the outer shell away from the frame to lift up and remove it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to simultaneously leverage the shell away and the motherboard up from the body of the shell.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a spudger, unclip the bottom left snap to unplug the keyboard. The image shows the motherboard rotated 90 degrees counterclockwise
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using your thumb, push the tab on the right side of the motherboard over to the right and then push downward to unclip the keyboard. It should fall away.
-
Cancelar: No complete esta guía.
5 personas más completaron esta guía.