Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove four 6mm #1 Phillips head screws from under the basket area.
-
Remove the single 6mm #1 Phillips head screw from the side of the unit.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently pry the upper cover off the unit above the brew basket and above the water reservoir base and along the side of the upper cover.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the single 6mm #1 Phillips head screw from the top of the unit. (The two smaller screws should remain attached.)
-
Using an extension, remove the two 6mm Phillips head screws from the side of the frother motor pivot.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pinch power connector and pull lighly to separate.
-
Pull motor straight up to separate from unit.
-
Un comentario
Awesome write-up. But does anyone know where a replacement frother arm can be purchased?