1. Slide the eyepiece up and off the viewfinder.
    • Slide the eyepiece up and off the viewfinder.

    Agregar Comentario

  2. Using a PH000 screwdriver, remove the two 4.8mm Phillips screws from the back of the viewfinder.
    • Using a PH000 screwdriver, remove the two 4.8mm Phillips screws from the back of the viewfinder.

      • Some screws may be JIS. Be wary of this if your PH000 does not feel like it is properly gripping the screws.

    Agregar Comentario

    • Remove the two 6.4mm Phillips screws on the right side of the camera, near the SD card slot.

    Agregar Comentario

    • Remove the two 6.4mm Phillips screws on the left side of the camera, near the I/O ports.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • On the bottom of the camera,

      • remove the two 5.3mm Phillips screws

      • and the other two 6.3mm Phillips screws.

    Agregar Comentario

    • Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step.

    Agregar Comentario

    • Lift the rear case off of the back of the camera.

    • Don't pull the casing completely off yet, as the ribbon cables are still connected.

    • Be mindful of the two clips, making sure to keep the bottom panel far enough away to clear them.

    Agregar Comentario

    • Set the rear casing off to the side so you can access the ZIF connectors.

    • The orientation shown in the picture seems to be the best position for the casing to sit comfortably without stressing the ribbon cable connections.

    Agregar Comentario

    • Disconnect the ribbon cables from their respective ZIF connectors on the logic board.

    Agregar Comentario

    • Separate the rear casing from the camera.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

8 personas más completaron esta guía.

Ryan Lutz

Miembro Desde 27/09/11

2,726 Reputación

3 Guías creadas

good guidance,easy to follow,thanks

ramalingeswarao kaza - Contestar

I want to replace my Nikon D90 DSLR bad LCD, this guide will save me from costly repairs.

ramalingeswarao kaza - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 17

Todo El Tiempo: 2,961