Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the lens/flash assembly 90 degrees, until you see the two Phillips #00 screws,
-
Remove the two screws with a Phillips #00 screwdriver.
-
Flip the flash so that you can access the remaining two screws. Remove these screws following the same method as before.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the camera up-side down.
-
Remove the two Phillips #00 screws located near the battery compartment.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the memory card compartment cover.
-
You can now see four screws under the cover. Remove all four screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use your thumb to carefully lift the bottom side of the casing near the battery.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to flip the tabs that hold the screen.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully lift the LCD from the bottom. It should come out fairly easily.
-