Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Bring the heat gun one to two inches from the edges of the display to melt the display adhesive.
-
Spend equal amounts of time applying heat around the entire edge of the phone.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Attach the suction cup to the display slightly to the left of center.
-
Exert a moderate force to pull on the suction cup. The display will come loose.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert the opening tool inside the loosened edge.
-
Gradually work the opening tool around the edge of the entire screen to cut through the adhesive.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Press down on the fingerprint sensor with the display slightly raised to disconnect it from the display.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the one 5mm Torx-5 screw located by the connector cables in the top right corner of the device.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grab the unscrewed metal plate with your blunt tweezers.
-
Slide the metal plate to the left and then out to remove it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disengage the two cable connectors by gently prying beneath the edge of the connector with the opening tool.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift up the detached right connector from its housing using blunt tweezers.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the nine black 5mm Torx-5 screws.
-
Remove the seven silver 5mm Torx-5 screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the metal cover by prying underneath it with the opening tool.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grab ahold of the fingerprint sensor and push it through the opening in the metal cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the fingerprint connector by gently prying underneath the connector with the opening tool.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disengage the two cable connectors by gently prying beneath the edge of the connector with the opening tool.
-