Introducción
Use this guide to replace your Defy's display assembly. Replacing the display assembly will give you a new front glass panel and digitizer.
Qué necesitas
-
-
-
Separate the Frame + Digitizer, the LCD and the mainboard.
If you change the whole glass/digitizer and plastic frame around it: remove all rubber things from the old one and place in the new specially the orange one around the microphone hole. If you miss this one there is going to be an echo when calling without headset!!!
-
-
-
Now, using a plastic opening tool, carefully insert it between the frame and the glass and force it slowly to remove the adhesive. You may also heat it to help.
-
Now, Remove the rest of adhesive from the frame to better apply the new digitizer on it.
-
Follow this backwards to reassemble the mobile.
Do not try to force the glass from the frame! First gently heat the glass near the sides using a hot air gun or simply by holding it over a small gas stove flame (at least 15cm away). The heat must not be enough to burn your hand and therefore not damage the plastic either! Just gently push on the inside of the glass until it starts to separate from the frame. Any force can warp or damage the frame so be patient.
You cannot simply reverse the instructions to reassemble! An important step is to clean the remaining traces of adhesive with a cotton bud dipped in some alcohol, and then apply strips of special 2mm wide, black, elastic double-sided adhesive tape to the frame in preparation to glue in the new screen and digitizer. Ensure you cut the tape so it does not obstruct any of the holes for the 4 home key LEDs, earphone, proximity detector, etc. Then remove the backing from the tape and the new screen, pass the ribbon cable through the slot, and drop the screen into place.
i just changed the LCD from my defy+..
i think it's a nice giude. maybe some pics could be turned around, but it's ok!
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
11 personas más completaron esta guía.
Also remove the SIM card. (You do not need to remove the micro SD card.)
Anthony Berkow - Contestar
I tried the same however , the lower right side corner is not responding to the the touch.
Have any one got the same issue...
DIY - Contestar