Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use your fingers to push both battery release tabs away from the battery, and lift the battery out of the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three identical Phillips screws from the memory door.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the memory door up enough to get a grip on it, and slide it toward you, pulling it away from the casing.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two Phillips screws in the battery compartment near the latch.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the following 6 screws:
-
Two 10 mm T6 Torx screws on either side of the RAM slot.
-
Four 14.5 mm Phillips screws along the hinge.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four Phillips screws on the port side of the computer.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Rotate the computer 90 degrees and remove the two Phillips screws from the rear of the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Rotate the computer 90 degrees again and remove the four Phillips screws from the side of the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift up at the rear of the case and work your fingers along the sides, freeing the case as you go. Once you have freed the sides, you may need to rock the case up and down to free the front of the upper case. This stage can be quite tricky. Over the DVD reader are 4 tabs set back which pull out vertically.
-
Note that the two small tongues on the left hand front of the upper case may bend while you remove the upper case. When re-installing, you may need to bend them back to fit in the grooves in the lower case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the trackpad and keyboard ribbon cable from the logic board, removing tape as necessary.
-
Remove the upper case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the two antenna cables attached to the Airport Extreme card.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Deroute the Airport antenna cables from their channel in the left speaker.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the iSight, inverter, and left fan cables from the logic board by gently pulling in the direction of each cable.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the display data cable from the logic board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the silver T6 Torx screw securing the ground loop on the display data cable to the casing.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Support the display with one hand while removing the following 3 screws:
-
Two 9.5 mm silver T6 Torx screws with threads on only part of the shaft on the inside of the display hinges.
-
One 9.5 mm silver T6 Torx screw with threads on the entire shaft on the outside of the left hinge.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grasp the display assembly on both sides and lift it up and out of the computer.
-
Cancelar: No complete esta guía.
26 personas más completaron esta guía.
