Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
-
Utiliza los dedos para empujar las dos lengüetas de liberación de la batería y sácala del ordenador.
-
-
-
Retira los dos tornillos Phillips de 2,8 mm en el compartimento de la batería cerca del pestillo.
-
-
-
Levanta la parte trasera de la caja y desliza los dedos por los laterales, liberando la caja a medida que avanzas. Una vez que hayas liberado los laterales, es posible que tengas que mover la caja hacia arriba y hacia abajo para liberar la parte delantera de la caja superior (hay algunos clips de plástico ocultos que hay que quitar).
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the iSight cable from the logic board by sliding the cable to the left and out of its connector.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the inverter, left fan, and left ambient light sensor cables by placing a spudger beneath each cable and lifting up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Peel up the left ambient light sensor cable from above the left fan, removing tape as necessary.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the following 3 screws:
-
One 6.2 mm black T6 Torx screw from the right side of the fan.
-
Two 9.4 mm silver T6 Torx screws from the left side of the fan.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the left fan up and carefully peel up the tape securing the fan to the heat sink as you go.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the hard drive and ExpressCard connectors from the left side of the logic board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the three antenna cables attached to the Airport Extreme card.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the single black T6 Torx screw located just above the Airport Extreme card.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the Airport Extreme card up and slide it out of its connector.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Deroute the Airport antenna cables from their channel in the left speaker.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Peel up the orange hard drive cable from above the ExpressCard cage.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the speaker cable from the corner of the left I/O board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the left speaker assembly out of its housing and place it in the area previously occupied by the left fan.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the large gray and black power cable from the left I/O board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the following 5 screws/standoffs:
-
Four black T6 Torx screws securing the left I/O board to the lower case.
-
One 4 mm standoff located between the audio jacks.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift up the right side of the left I/O board and slide it out of the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three silver Phillips screws securing the ExpressCard cage to the left I/O board.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.