Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
-
Apaga el Mac mini, desconecta todos los cables y dale la vuelta.
-
Inserta el Jimmy en la grieta entre la carcasa superior de aluminio y la carcasa inferior de plástico.
-
Insertar traducción aquí
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grasp the Airport antenna board and lift it off of the two plastic posts holding it in place. You may need to push back the black plastic tab jutting through the lower left corner of the board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the yellow tape securing the power button cable to the black plastic framework.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three black Phillips screws securing the plastic framework to the logic board and lower case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grasp the optical drive and mass storage unit in one hand and lift up enough so that you can see beneath it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With your free hand, pull the Bluetooth cable up from Bluetooth board and unplug the Airport antenna cable from the right of the Airport card. Caution: both of these connections are very small. When re-assembling unit after repair, you may want to remove the two screws holding the airport card to the assembly and lift the card up and out to re-attach the cables.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four silver Phillips screws attaching the optical drive to the black plastic framework (two on each side).
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the yellow tape securing the Bluetooth antenna cable to the black plastic framework.
-
Lift the silver Bluetooth antenna board out of its slot.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the mass storage assembly over and disconnect the speaker and fan cables from the interface board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the mass storage assembly back over. Grasp either side of the plastic framework and push the optical drive away from you with your thumbs on either side of the bezel until you hear it pop free.
-
Lift the optical drive and attached interface board up from the assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two silver Phillips screws connecting the interface board to the optical drive.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grasp either side of the interface board and wiggle it free of the optical drive.
-
Cancelar: No complete esta guía.
20 personas más completaron esta guía.
Documentos Adjuntos
Un comentario
If you are careful, there is no need to remove the whole storage unit and can unscrew the optical drive after removing the top case. The screws at the back are a bit tricky, but not impossible to remove while the storage unit remains attached to the logic board and bottom cover.