Repara tus cosas Únete a la comunidad Tienda

Logitech G29 Driving Force Pedal Replacement

Introducción

This replacement is not bad other than the fact there are a ton of screws. With a little soldering knowledge and fixing knowledge this guide will take you through the steps needed to replace a pedal.

Qué necesitas

  1. Logitech G29 Driving Force Pedal Replacement, Pedal: paso 1, imagen 1 de 1

    • Start by removing the 12 #1 Phillips that holds the pedals the the back board

    Editar

  2. Logitech G29 Driving Force Pedal Replacement: paso 2, imagen 1 de 1

    • Next remove all 12 of the J0 Phillips

    Editar

  4. Logitech G29 Driving Force Pedal Replacement: paso 3, imagen 1 de 1

    • For the last Couple screws remove the 2, 2.5 Allans located on the pedals.

    • I would suggest only taking the 2 Allans out of the pedal that needs fixing. All others can stay

    Editar

  5. Logitech G29 Driving Force Pedal Replacement: paso 4, imagen 1 de 1

    • Now that all screws are loose the back plate should be able to be removed reviling the pedals.

    Editar

  6. Logitech G29 Driving Force Pedal Replacement: paso 5, imagen 1 de 1

    • If pedal is unresponsive start by checking the gear mesh.

    • If gear mesh is not connecting check to make sure everything is tight.

    • If gears are stripped or broken off get replacement gears.

    Editar

  7. Logitech G29 Driving Force Pedal Replacement: paso 6, imagen 1 de 1

    • If gears are fine check wire connections.

    • If red wires are loose resouder and make sure the connection is good.

    • If the black ground wire is loose, tighten up.

    • If none of these fix the problem go ahead and source a new pedal to install.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 12

Ultimos 7 días: 51

Ultimos 30 días: 232

Todo El Tiempo: 887