Saltar al contenido principal

Introducción

This guide will show you how to disassemble the back panel for the device.

This guide is also a prerequisite guide for other hardware part replacement.

Partes

No se especificaron partes.

  1. Before you proceed, make sure your computer is turned off and is not connected to any power source.
    • Before you proceed, make sure your computer is turned off and is not connected to any power source.

    • Remove the single 7 mm Phillips #1 screw securing the optical drive.

    • Be sure to store the screws carefully as they are easy to lose. A magnetic project mat is recommended

  2. Carefully remove the optical drive bracket by pulling the bezel away from the laptop. Carefully remove the optical drive bracket by pulling the bezel away from the laptop. Carefully remove the optical drive bracket by pulling the bezel away from the laptop.
    • Carefully remove the optical drive bracket by pulling the bezel away from the laptop.

  3. Using the Phillips #1 screwdriver, remove the twelve screws around the back panel from the laptop. Using the Phillips #1 screwdriver, remove the twelve screws around the back panel from the laptop.
    • Using the Phillips #1 screwdriver, remove the twelve screws around the back panel from the laptop.

  4. Use an opening tool to pry out the  back cover. Use an opening tool to pry out the  back cover. Use an opening tool to pry out the  back cover.
    • Use an opening tool to pry out the back cover.

  5. Remove the back panel by pulling it up and away from the laptop. Remove the back panel by pulling it up and away from the laptop. Remove the back panel by pulling it up and away from the laptop.
    • Remove the back panel by pulling it up and away from the laptop.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 4

Ultimos 7 días: 23

Ultimos 30 días: 131

Todo El Tiempo: 1,164