Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove two 9 mm Phillips #1 screws.
-
The screws are located on the top of where the K-Cup would be.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once you remove the screws, the top cover should come out.
-
You will then want to remove these screws which are the same size.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once you get those removed, you are going to want to pull on the hose until it pops off.
-
Once the hose comes off, the needle will fall out by itself.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Next, after the removal of the hose on the top by simply pulling it off, remove the following four Phillips #1 screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once you take off the screws, this part of the handle will come off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To pull this part off, pull inwards with the these tabs located on both sides of the handle assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Next, remove these two Phillips #1 screws to allow the release of the actual handle from the frame.
-
For the O rings, we used the plastic prying tools. Just keep in mind that you might want to hold one side of the O ring down while trying to pry off the other side with the other.
-
Once you get the O rings on both sides out, you can pull the handle by pulling on each side.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once you pull both sides, the handle will come off as shown.
-