Saltar al contenido principal

Introducción

This guide will show you how to open the body of the AngelSound to disconnect the motherboard from the case. You will need knowledge of how to use a soldering iron station. For more information regarding soldering visit: Soldering Skills

Partes

No se especificaron partes.

  1. Jumper Angelsounds JPD-100S Motherboard Replacement, Motherboard: paso 1, imagen 1 de 1
    • Access the battery compartment

    • Remove the battery compartment lid and set it aside.

    • Disconnect the battery and set it aside.

  2. Jumper Angelsounds JPD-100S Motherboard Replacement: paso 2, imagen 1 de 2 Jumper Angelsounds JPD-100S Motherboard Replacement: paso 2, imagen 2 de 2
    • Puncture the sticker in the battery compartment with a spudger to access the screw beneath it.

  3. Jumper Angelsounds JPD-100S Motherboard Replacement: paso 3, imagen 1 de 1
    • Remove the 7mm Phillips #1 screw from the battery compartment.

    • Place the screw in a secure place.

  4. Jumper Angelsounds JPD-100S Motherboard Replacement: paso 4, imagen 1 de 2 Jumper Angelsounds JPD-100S Motherboard Replacement: paso 4, imagen 2 de 2
    • Begin prying open the device.

    • Insert a plastic opening tool into the side groove about 2cm from the pink plastic component and pry open one side of the device.

    • Once the side is separated, leave the opening tool inside to prevent the two sides from closing.

  5. Jumper Angelsounds JPD-100S Motherboard Replacement: paso 5, imagen 1 de 2 Jumper Angelsounds JPD-100S Motherboard Replacement: paso 5, imagen 2 de 2
    • Insert another plastic opening tool into the groove opposite to the side of the tool already inserted.

    • Create separation on that side until the white plastic component comes off entirely.

    • Place the white plastic component in a secure place.

  6. Jumper Angelsounds JPD-100S Motherboard Replacement: paso 6, imagen 1 de 1
    • With your hand, remove the pink component.

  7. Jumper Angelsounds JPD-100S Motherboard Replacement: paso 7, imagen 1 de 1
    • Remove the 7mm Phillips #1 screw in the middle of the motherboard.

Linea de Meta

Deron Rogers

Miembro Desde 31/08/15

271 Reputación

2 Guías creadas

Equipo

USF Tampa, Team 6-1, Remmell Fall 2015 Miembro de USF Tampa, Team 6-1, Remmell Fall 2015

USFT-REMMELL-F15S6G1

6 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 1

Todo El Tiempo: 165