Jeans 2-Hole Button Replacement

Introducción

This is a simple repair of adding a two-hole button onto a pair of jeans. This repair requires a needle, thread, fabric scissors, and a fabric marker. After following the steps in this guide, a two-hole button should be firmly attached to a pair of jeans. Keep in mind that the needle being used in sharp and is hard to spot if dropped.

Is a two-hole button just not looking how you’d like? Here is a link to re-attach a four-hole button! Coser un botón

Qué necesitas

Paso 1 2-Hole Button

Jeans 2-Hole Button Replacement, 2-Hole Button: paso 1, imagen 1 de 1

Find a thread color that matches the fabric you are sewing the button on to.

Editar

Paso 2

Loop the thread through the eye of the needle.
Tie a small knot around the eye of the needle with the thread.
Make sure the knot is tight!

Editar

Paso 3

Thread the needle through the fabric from the inside out.
Tie a knot at the end of the thread after pulling most of it through the fabric.

Editar

Paso 4

Jeans 2-Hole Button Replacement: paso 4, imagen 3 de 3

Sew the thread in a small 'x' where you would like to place the button.
If you don't want to sew, then mark the spot with a white fabric marker.

Editar

Paso 5

Jeans 2-Hole Button Replacement: paso 5, imagen 3 de 3

Place the button over the small stitched 'x' or fabric marker spot.
Thread the needle through the left hole of the button from the inside out.
Pull the needle and thread all the way through the fabric.
If you can't find the hole of the button, thread the needle through the fabric first and then through the button hole.

Editar

Paso 6

Jeans 2-Hole Button Replacement: paso 6, imagen 3 de 3

Cross the needle over to the right hole of the button.
Thread the needle all the way through the fabric.
This step creates the first stitch.

Editar

Paso 7

Repeat Steps 6-7 four to five times, until you have a secure button.

Editar

Paso 8

Create a thread shank on the inside of the fabric by looping the thread around a stitch.
Pull the thread all the way through the hole until it is tight.
Repeat this 2-3 times.
Tie a knot after the final stitch to secure the stitches.